4) You will need to have on hand water leak tape, small gas torch, solder, flux, plumbing sandpaper, pipe cutter, gas tape (to seal gas line) and maybe some pipe glue. Ask the sales person at the hardware store for a more defined list.
85. Know your IRPCS International Rules for Preventing Collisions at Sea and be aware of how you should approach water line repair or cross a traffic separation scheme TSS).
Plumbers are at a high risk for health problems. This is because they are regularly exposed to many different illnesses and infections. They can contract psittacosis and histoplasmosis from the regular contact they have with animal droppings. Plumbers also see regular exposure to harmful chemicals and elements like lead and the other chemicals that can be found in the plumbing materials they work with on a regular basis.
Depending on your repair job you might need a bucket that will fit below the sink trap, as well as some rags and newspaper. Masking tape is useful for labeling and for wrapping around the heads of the wrench to protect your chrome tap handles. Rubber gloves are recommended, particularly when working with the toilet, but there are greases and glues that you may not want on your hands.
Here are some general cautions. Do not begin jobs on holidays, weekends, or at times when plumbers raise their rates or are difficult to reach. Do start early leaving plenty of daylight to call a plumber if something goes wrong. Study the situation carefully. Think about what might happen if something suddenly broke and what the effects would be. Old corroded copper tubing might break in the wall when you are wrenching an angle stop that supplies the water line repair to your toilet. A flood in the wall could be costly. If the angle stop, on the other hand, is new and shuts off easily and you have another toilet in the house then it might make sense to repair the toilet yourself. Be honest, too. Are you handy with tools? Did you do well in shop classes in school?
Plumbers should always have a durable and long lasting ventilation system ready for any job. Having clean air in ready supply can make many tougher jobs go much more smoothly and will cut down on the risk to the plumbers considerably.
Then, you can take your new shower parts home and reinstall them in the inner assembly. It is very important that everything be aligned properly and tightened to prevent leaks. Beware of over tightening, however, since this can also cause problems. Once you are sure everything is installed properly, replace the cover plate and turn the water back on to test your repair work. With a little bit of work, your do-it-yourself shower repair project can be a success. It does not take an expert, just a little effort and know how.